Dryer keeps tripping breaker. If you’re someone who has to deal with doing laundry constantly, then we know that using a dryer can become a necessity in not only getting your clothes dry but also in quick time.
However, using a dryer excessively may be detrimental over time to your household appliances because they may overwork themselves or burn out their circuits.
If your dryer keeps tripping the breaker every time you turn on the machine, it could either mean an issue with the wiring of your house and circuit breaker or that your dryer’s motor needs servicing.
A brief read of this handy guide will help you find information about when to be concerned about your dryer blowing circuit breakers.
Table of Contents
Dryer Keeps Tripping Breaker
We will discuss here the causes of why the dryer keeps tripping the breaker.
1. Faulty Dryer Motor
Inspecting the machine before testing the electrical system is a good idea. After using your dryer for ten minutes, you should examine the motor.
Remove the engine and unhook the power cord to check for continuity. Utilize a multimeter to check for continuity (a tool used to check electronic circuitry).
Change out damaged motors for new ones. But bear in mind that there are internal components as well, which are crucial to maintaining everything’s efficiency but can also become clogged.
This is why cleaning out your machine regularly is vital, especially if you’ve observed that your clothes are drying slower than usual or exhibiting other minor irregularities like uneven drying.
2. Terminal Block With Loose Wires
The dryer’s electrical power passes through a terminal block before being sent to various parts of the dryer.
Your dryer may switch off your breaker midway through a cycle, just like an older circuit board might have done in the past, if one or more wires in the terminal block have fallen loose.
Run a vigorous drying cycle to see if your machine’s terminal block has any loose wires creating arcing within the family bin while it is on and unintentionally tripping your circuit switch (also known as blowing a fuse).
3. Faulty Heating Element
The heating element is an essential part of your dryer. It provides the needed heat for the clothes to properly dry during and after the cycle is complete.
In most models, you can access this element once you remove the front panel from your machine. Excess moisture sometimes leads to corrosion, causing the replacement to fail.
With most products on our site having a thorough breakdown of their parts in each review, it’s very easy for us to keep an eye on any breakages and replacements that might be in need depending on how much use your machine gets during any given month.
4. Faulty Thermostat
This is another example of a mechanism causing your machine to trip the breaker.
Such breakers are commonly used on various home appliances and electrical devices to protect them from overheating, and each one has a specific maximum electrical capacity.
If a faulty mechanism causes a machine to deviate from its normal programming, it may pull in more current than the breaker can handle, tripping the device.
Why does my dryer keep tripping the electric?
A fuse blowing or an RDC tripping usually points to an issue with the power socket or the appliance itself. As a first step, we recommend checking that the device is connected correctly, with fuses and RCDs set up correctly to prevent overloading circuit breaks, which tends to be a common mistake.
Check that all appliances are correctly connected and that some are not on the same circuit, i.e., a washing machine must not be on the same fuse as a tumble dryer!
How many times can a breaker trip?
With 100 amp breakers, they are intended to be used 10,000 times in total, or 6000 trips at rated current and 4000 trips without wind.
Most likely, unless they’re using the breakers as switches and there’s the correct situation behind it, they won’t see that many actions.